If there is an EET in the Flightplan section of 'Activity Info', it will be used to calculate touch down and block on when setting departure or delaying (red selections). This value can also be added or edited manually.
Once a value for EET is available, this will also be visible on the leg tooltip. The EET line will show the landing and arrival time in UTC as well as in local time in parenthesis. After that in square brackets the out-taxi times, the EET value, and the in-taxi times. These taxi times are defined in the Station Taxi Times table.
Calculating times
If the user enters a new departure/delay time and the 'Always recalculate' box is ticked, the times will be recalculated.
Settings
Note: There is a setting to use EET to calculate touch down and block on when receiving MVT messages to the system.
Setting: "UseEETToCalculateBlockOn" = TRUE or FALSE.
Set to TRUE if you want MVT messages to use EET when calculating Touch Down and On Block. Also, note that the flight puck on the Gantt will adjust its length according to the calculated values.
